Mitutoyo SJ-210 - Data To Be Saved and Storage Media


No. 99MBB122A

9-2
9.1 Data To Be Saved and Storage Media
■ Data to save/load and its media
Data saving and loading is outlined below, where data is divided into two groups according
to data handling.
Data group Stored contents Storage media
Measurement
conditions
Measurement conditions Internal memory (10 files max.),
or Memory card (500 files max.)
Measured
data
Measured profile data,
calculation results
Internal memory (1 file of the latest
measurement result),
or Memory card (10,000 files max.)
NOTE
• When data is loaded, the existing SJ-210 main unit setup is overwritten with the above
described “storage contents” that are loaded together.
9.1.1 Handling the memory card
A memory card can be inserted in the slot on the rear side of the SJ-210.
Insert the memory card following the procedures below.
■ Inserting the memory card
IMPORTANT
• Insert the memory card straightforward correctly fitting in the memory card slot guide.
Otherwise the connector pins at the recess may be damaged.
• Insert the memory card with the pin assignment side facing up.
• Insert or remove the memory card while the power of the SJ-210 is off.
1 Place your nail on the hollow provided on the rear cover, and push the rear cover in
the direction indicated by the arrow (1).
2 Pull the rear cover in the direction indicated by the arrow (2) and remove it.
Detaching the rear cover
㧔1㧕
㧔2㧕
Rear cover