Mitutoyo SJ-210 - Setting Data Output to Save Data

10. OPERATING ENVIRONMENT SETUP
No. 99MBB122A
10-17
10.3.3 Setting data output to save data
You can save calculation results and measurement data to the memory card when data
output is set to “Data storage”.
With this setting, calculation results and measurement data are saved to the memory card
when the [POWER/DATA] key of the SJ-210 is pressed.
NOTE
• The factory default setting for data output is “SPC”.
• After the power to the instrument is turned on, it may take more time than usual when
the data is saved for the first time.
■ Operating procedure (Refer to “■ Accessing the Operating Environment Setup Menu screen” in Section
10.1.)
Home screen to Main Menu  
1 Select “Data Output” with the [ ↑ ] [ ↓ ] keys, and press the
[Enter/Menu] key.
2 Select “Data storage” with the [ ↑ ] [ ↓ ] keys, and press the
[Enter/Menu] key.
TIP
• Press the [Esc/Guide] key to return to the previous screen.
Operating Environment
Setup menu screen
2SHUDWLQJ(QY