Mitutoyo SJ-210 - Saving Data to the Memory Card

13. SAVE / OUTPUT RESULTS USING [POWER/DATA] KEY
No. 99MBB122A
13-15
13.3 Saving Data to the Memory Card
You can save measurement data or screen images to the memory card by pressing the
[POWER/DATA] key.
13.3.1 Saving measurement results to the memory card
You can save measurement data to the memory card when data output is set to “Data
storage”.
With this setting, measurement data is saved to the memory card when the
[POWER/DATA] key of the SJ-210 is pressed. Measurement data is saved in a designated
folder in the main folder.
NOTE
• After the power to the instrument is turned on, the first time data is saved may take more
time than usual.
TIP
• The “*” displayed to the left of a folder means that it is the main folder.
For information about designating the main folder, refer to 9.3.2, “Specifying the main
folder”.
For information about setting data output, refer to 10.3.3, “Setting the data output to
save data”.
Main folder display
■ Operation procedure
1 Perform the measurement.
TIP
• For information about measurement, refer to Chapter 4, “MEASUREMENT
OPERATION”.
2 Press the [POWER/DATA] key.
 Measurement data is saved in a designated folder in the main folder.