No. 99MBB122A
7-34
7.13.3 Loading measurement conditions
You can load measurement conditions that have been saved to either the internal memory
or the memory card (optional).
To load measurement conditions, first display the Measurement Conditions Read screen
from the Measurement Conditions Setup screen, then choose the read source (internal
memory or memory card). Then, you can choose a file, etc.
IMPORTANT
• When using the built-in battery, make sure it is sufficiently charged. If measurement
conditions are loaded while the battery power is low, the SJ-210 may shut off while the
data is being read.
■ Operating procedure (Refer to “■ Accessing the Measurement Conditions Menu screen” in Section 7.13.1.)
Home screen to Main Menu
1 Select “Read” with the [ ↑ ] [ ↓ ] keys, and press the [Enter/Menu] key.
2 Select the read source with the [ ↑ ] [ ↓ ] key, and press the
[Enter/Menu] key.
“Direct”: Internal memory
“Memory Card”: Memory card
3 Select the measurement conditions to be loaded with the [ ↑ ] [ ↓ ] keys,
and press the [Enter/Menu] key.
The Home screen is restored.
Measurement Condition
Load Select screen
Internal Memory Load screen
Measurement Conditions Menu
screen
To Next Page
Loading...
