No. 99MBB122A
10-8
10.3.2 Setting the data output to a printer
You can print out measurement results or conditions from the SJ-210 when data output is
set to “Printer”.
Printing commences when the [POWER/DATA] key is pressed.
There is also a function for automatic printing when a measurement is complete using the
SJ-210.
TIP
• For information about connecting the SJ-210 to a printer, and about printing, refer to
13.2, “Printing to an External Printer”.
■ Operating procedure (Refer to “■ Accessing the Operating Environment Setup Menu screen” in Section
10.1.)
Home screen to Main Menu
1 Select “Data Output” with the [ ↑ ] [ ↓ ] keys, and press the
[Enter/Menu] key.
2 Select “Printer” with the [ ↑ ] [ ↓ ] keys, and press the [Enter/Menu]
key.
NOTE
• The factory default setting for data output is “SPC”. When
using a printer for data output, make sure to change the
output setting to “Printer”.
3 Confirm the communication status with the printer.
TIP
• For information about confirming the printer's
communication status, refer to 13.2.2, “Setting the printer
communication conditions”.
Print Setup screen
Data Output Setup screen
ironment Setup menu
screen
To Next Page
Loading...
