Mitutoyo SJ-210 - Setting the Data Output to Hard Copy

No. 99MBB122A
10-18
10.3.4 Setting the data output to hard copy
You can perform an image capture of displayed calculation results when data output is set
to “Hard copy”.
With this setting, graphical data of the displayed calculation results image is saved to the
memory card when the [POWER/DATA] key of the SJ-210 is pressed.
NOTE
• The factory default setting for data output is “SPC”.
■ Operating procedure (Refer to “■ Accessing the Operating Environment Setup Menu screen” in Section
10.1.)
Home screen to Main Menu  
1 Select “Data Output” with the [ ↑ ] [ ↓ ] keys, and press the
[Enter/Menu] key.
2 Select “Hard copy” with the [ ↑ ] [ ↓ ] keys, and press the
[Enter/Menu] key.
TIP
• Press the [Esc/Guide] key to return to the previous screen.
Operating Environment
Setup menu screen
Data Output Setup screen