10. OPERATING ENVIRONMENT SETUP
No. 99MBB122A
10-7
10.3.1 Setting the data output to SPC
You can output calculation results from the SJ-210 to a DP-1VR when data output is set to
“SPC”.
With this setting, calculation results are output when the [POWER/DATA] key on the
SJ-210 or the [DATA] key on the DP-1VR is pressed.
NOTE
• The factory default setting for data output is “SPC”.
TIP
• For information of connecting the SJ-210 to a DP-1VR, and about SPC data output,
refer to 13.1, “SPC Data Output”.
■ Operating procedure (Refer to “■ Accessing the Operating Environment Setup Menu screen” in Section
10.1.)
Home screen to Main Menu
1 Select “Data Output” with the [ ↑ ] [ ↓ ] keys, and press the
[Enter/Menu] key.
2 Select “SPC” with the [ ↑ ] [ ↓ ] keys, and press the [Enter/Menu] key.
TIP
• Press the [Esc/Guide] key to return to the previous screen.
Data Output Setup screen
Operating Environment
Setup menu screen
To Next Page
Loading...
