Mitutoyo SJ-210 - Retracting the Detector

15. MAINTENANCE AND INSPECTION OF SJ-210
No. 99MBB122A
15-3
15.2 Retracting the Detector
When moving the SJ-210 or not using it for a long period of time, retract the detector to
prevent damage to the detector or work piece caused by the detector tip interfering with
the work piece.
IMPORTANT
• Do not perform detector retraction when an extension rod (optional) is installed. The
extended detector is subject to an external force: This may cause breakage of the drive
unit.
• 㪩㪼㫄㫆㫍㪼㩷㫋㪿㪼㩷㪘㪚㩷㪸㪻㪸㫇㫋㪼㫉㩷㪸㫅㪻㩷㪸㪺㫋㫀㫍㪸㫋㪼㩷㫋㪿㪼㩷㫌㫅㫀㫋㩷㪹㫐㩷㫀㫅㫋㪼㫉㫅㪸㫃㩷㪹㪸㫋㫋㪼㫉㫐㪅
■ Detector retraction of the SJ-210 standard type
Detector retraction
■ Retraction procedure of the detector of SJ-210 standard type
NOTE
• In the SJ-210 retracting type and transverse tracing drive type, the detector escapes all
the way to the front with the detector tip down.
1 When the power is off, press the [POWER/DATA] key while holding down the
[START/STOP] key.
 This retracts the detector. During retraction, “Retraction in progress” is
displayed.
 The power turns off, upon completion of retraction.
Drive unit
Retraction
Detector
Direction of detector
movement