Mitutoyo SJ-210 - Evaluation profile display

5. MEASUREMENT RESULT DISPLAY
No. 99MBB122A
5-3
5.1.1 Switching the parameter display
When displaying the measurement results, the objective parameter to be displayed can be
switched to another customized parameter.
Each time the [PAGE] key is pressed, the displayed parameter that has been selected
using the parameter customize function changes in the following order: “Ra”
→ “Rq” → “Rz”
→ XXX.
The objective parameters to be displayed are limited to the parameters that have been
customized using the parameter customize function.
TIP
• For information about the parameter customize function, refer to 8.2, “Selecting the
Displayed Parameters (Parameter Customization)”.
• For information about switching the display directions, displaying multiple parameters
on one screen, and trace display, refer to 11.3, “Switching Calculation Results Screen”.
Switching the parameter display
5.1.2 Evaluation profile display
The measurement results can be displayed in the measured profile (evaluation profile).
The Evaluation Profile screen appears after the parameter that has been selected using
the parameter customize function.
Evaluation Profile screen
TIP
• For information about setting the display directions and whether to display the
evaluation profile or not, refer to 11.4, “Switching Evaluation Profile Screen”.
[PAGE] [PAGE]