Mitutoyo SJ-210 - Printing to an External Printer

13. SAVE / OUTPUT RESULTS USING [POWER/DATA] KEY
No. 99MBB122A
13-7
13.2 Printing to an External Printer
By connecting the SJ-210 to the printer (optional accessory) using the RS-232C printer
cable (optional accessory), you can print measurement conditions, calculation results,
evaluation profiles, and BAC or ADC contents.
NOTE
• Two types of printers are available to use with the SJ-210, but apart from the printer
cable and individual printer settings, you can print using similar operation procedures.
TIP
• You can load saved measurement data and print the results.
For information about loading measurement data, refer to 9.4, “Loading Measurement
Results”.
The operation flow for printing measurement results is described below.
There are two types of operations: general operations and operations on demand. The
former is performed regularly and the latter is performed as required. In the flow chart
below, solid lines indicate general operations and dotted line indicates operations on
demand.
Connecting the printer
→ 13.2.1, “Connecting the SJ-210 and the printer
”
Executing the actual measurement of the
roughness specimen
→ Chapter 4, “MEASUREMENT OPERATION”

Set calculation result output to “Printer”
→ 10.3.2, “Setting data output to Printer”
→ 13.2.3, “Printing calculation results and measurement conditions”
Loading saved data for printing
→ 9.4, “Loading Measurement Data”

When printing
When printing saved data

Setting the print items
ń´6HWWLQJWKHSULQWLWHP

omized parameters are displayed in 
Setting the printer communication conditions
→ 13.2.2, “Setting the Printer Communication Conditions”
