Mitutoyo SJ-210 - Outputting Measurement Results

No. 99MBB122A
16-4
16.4 Outputting Measurement Results
■ Outputting measurement results
Symptom/Error
display
Possible causes Remedies
Data output is not set to “SPC”.
Set the data output to “SPC”.
Refer to 10.3.1, “Setting the data output to SPC”.
SPC cable connection problem. Connect the SPC cable properly.
Power to the Digimatic Processor is off. Turn on the Digimatic Processor.
SPC data can not be
outputted.
When printout is started, no recording paper is
loaded on the Digimatic Processor.
Load the recording paper on the Digimatic Processor.
Data output is not set to “Printer”.
Set the data output to “Printer”.
Refer to 10.3.2, “Setting the data output to a printer”.
The SJ-210 is not properly connected with the
printer.
Connect the printer properly with the SJ-210.
When printout is started, no recording paper is
loaded on the printer.
Load the recording paper on the printer.
The printer head unit was raised. Position the printer head unit properly.
The settings of the SJ-210 baud rate and printer
baud rate are not identical.
Set the printer baud rate to the same numeric value
as that of the SJ-210 baud rate. (Set environment to
“Printer”, and then perform“ Checking
communication”.㧕
Next, turn off the power to the printer and SJ-210 (put
the SJ-210 in the auto-sleep mode), and then turn on
the both power again.
Abnormal temperature was generated on the
printer head.
Turn off the power to the printer once, and then turn it
on again after a while.
Printing-out to the external
printer can not be
performed.
Abnormal power was supplied to the printer. Use the AC adapter supplied with the printer.
If the error still occurs, contact your dealer or the
nearest Mitutoyo sales office.