Mitutoyo SJ-210 - Modifying the Traversing Speed

No. 99MBB122A
6-24
6.5.7 Modifying the traversing speed
Set the traversing speed according to the precision roughness specimen.
Traversing speed to select is restricted depending on the cutoff length (λc).
■ Operating procedure (Refer to “■ Accessing the Calibration Menu screen” in Section 6.2.)
Home screen to Main Menu   
1 Select “Cal. Condition” with the [ ↑ ] [ ↓ ] keys, and press the
[Enter/Menu] key.
2 Select “M-Speed” with the [ ↑ ] [ ↓ ] keys, and press the [Enter/Menu]
key.
3 Select target traversing speed with the [ ↑ ] [ ↓ ] keys, and press the
[Enter/Menu] key.
 Selected traversing speed appears on the Calibration Condition
Setup screen.
TIP
• Press the [Esc/Guide] key to return to the previous screen.
Calibration Menu screen
Traversing Speed Setup screen
Calibration Condition Setup screen
Calibration Condition Setup screen