Mitutoyo SJ-210 - Saving;Loading;Deleting;Renaming Measurement Conditions

7. MODIFYING MEASUREMENT CONDITIONS
No. 99MBB122A
7-27
7.13 Saving/Loading/Deleting/Renaming Measurement
Conditions
The SJ-210 can save up to 10 measurement conditions onto the internal memory, or up to
500 onto the memory card (optional).
Saved measurement condition files can also be deleted or renamed.
IMPORTANT
• A microSD card is used as the memory card.
microSD
TM
is the registered trademark of the SD Association.
A microSD Logo is the registered trademark.
In parts of this manual, “microSD
TM
card” is described as “microSD card” or “memory
card”. While designed to comply with existing standards, due to standards changes or
additions, or the non-support of SPI mode, etc, some microSD cards may not be
supported. Use the SD card designated by Mitutoyo (Part No. 12AAL069).
• Before use, the memory card must be formatted using the SJ-210. The memory card
may not function properly when formatted in a device other than the SJ-210. For
information about formatting the memory card, refer to 10.10.1, “Formatting the memory
card”.
• Connect the AC adapter to prevent power to the instrument from being interrupted
during operation.
• When using the built-in battery, make sure it is sufficiently charged. When operations
are performed when the battery power is low, the SJ-210 may shut off during operation.