No. 99MBB122A
7-1
7 MODIFYING
MEASUREMENT
CONDITIONS
In this chapter, measurement conditions are set or modified
according to surface roughness parameters, degree of roughness,
conditions of the location measured, etc.
The SJ-210 is compatible with each of the following roughness standards: JIS1982,
JIS1994, JIS2001, ISO1997, ANSI, and VDA.
Referring to Chapter 18, “REFERENCE INFORMATION”, set up the measurement
conditions according to the roughness standard to be complied with.
■ About modifying the measurement conditions
Since measurement condition items to be set according to the standard are interrelated,
setting a condition may also determine some other relevant conditions within the SJ-210.
For some measurement conditions, some choices may not be available due to being fixed
for that standard, or because of other conditions.
For more information on the relationships between these measurement conditions, refer to
7.2, “Modifying the Roughness Standard” through 7.11, “Modifying the Measuring Range”.
To Next Page
Loading...
