Mitutoyo SJ-210 - Automatic Printing after Completing Measurement; Stylus Alarm; Function Restriction

No. 99MBB122A
12-6
12.8 Automatic Printing After Completing Measurement
When the auto-print function is enabled, a measurement result can be printed when a
measurement is completed.
TIP
• For information about setting the Auto-print, refer to 10.3.2, “Setting the data output to a
printer”.
12.9 Stylus Alarm
The stylus alarm function cumulates the measured lengths, and displays the message
when designated threshold value exceeds the cumulative distance.
TIP
• For information about setting the Stylus Alarm, refer to 6.7, “Setting the Stylus Alarm”.
• A message is displayed every time the power is turned on. Set the setting of the
threshold to 0.0 when you do not want the message displayed.
12.10 Function Restriction
To prevent the settings (such as measurement conditions) from being modified, operations
for each setup item on the Main Menu can be disabled. To disable these operations, set
the password.
The setup items which the operation functions can be restricted are as follows.
 Calibration measurement
 Measurement conditions
 Measured data
 Parameter
 Operating environment setup
 Screen change
 N (sampling lengths) result
TIP
• For information about setting the function restriction, refer to 10.9, “Restricting
Operation Functions (Customization)”.