Mitutoyo SJ-210 - Nosepiece for flat surface

14. INSTALLING THE SJ-210 WITH OPTIONAL ACCESSORIES
No. 99MBB122A
14-3
■ Nosepiece for flat surface
Used to protect the detector when measuring a flat workpiece that is smaller than the
SJ-210.
 Dimensions and application example
Dimensions and application example of the nosepiece for flat surface
 Attaching the nosepiece for flat surface
NOTE
• When attaching the nosepiece to the drive/detector unit, exercise care so that it does
not interfere with the detector body.
1 Fit the SJ-210 detector into the slot of the nosepiece.
2 Using the supplied Allen wrench, tighten the two screws shown in the
following figure.
Attaching the nosepiece for flat surface
Drive
Nosepiece for flat surface
Work piece
SJ-210
Support feet
Nosepiece for flat surface
Drive
Nosepiece for flat surface

No. 12AAA217
Screw
Detector