Mitutoyo SJ-210 - Renaming Saved Measurement Conditions

7. MODIFYING MEASUREMENT CONDITIONS
No. 99MBB122A
7-37
7.13.5 Renaming saved measurement conditions
You can rename measurement conditions saved in the internal memory or on the memory
card.
IMPORTANT
• When using the built-in battery, make sure it is sufficiently charged. If measurement
conditions are renamed while the battery power is low, the SJ-210 may shut off while the
data is being renamed.
■ Operating procedure (Refer to “■ Accessing the Measurement Conditions Menu screen” in Section 7.13.1.)
Home screen to Main Menu  
1 Select “File Rename” with the [ ↑ ] [ ↓ ] keys, and press the
[Enter/Menu] key.
2 Select the save location that has the measurement conditions you
want to rename with the [ ↑ ] [ ↓ ] keys, and press the [Enter/Menu] key.
“Direct”: internal memory
“Memory Card”: memory card
3 Select the measurement conditions file name to be modified with the
[ ↑ ] [ ↓ ] keys, and press the [Enter/Menu] key.
Measurement Condition File
Rename Selection screen
File Rename screen
Measurement Conditions
Menu screen