No. 99MBB122A
8-14
8.4 Parameter Detail Settings
Calculation conditions can be set as necessary for parameters such as Sm, Pc, Ppi, Rc,
HSC, etc.
8.4.1 Setting calculation conditions when Sm, Pc, Ppi, or Rc is selected
When the “Sm”, “Pc”, or “Ppi” parameter is selected, the height of the count level, a
calculation condition, must be set. Profile Element restriction definition settings can also be
made.
Profile Element restriction definition (when the height of the count level is 10%)
(1) Zp / Zv 㧦 Zp>Zmin, Zv>Zmin Zmin=10% of Rz
(2) Zt 㧦 Zt>Zmin Zmin=10% of Rz
10% of Rz
Evaluation profiles
Mean line
Evaluation profiles
Mean line
10% of Rz
or more
Peak
Peak
Valley
Valley
Peak
Peak
Peak
Valley
Valley
Valley
To Next Page
Loading...
