Mitutoyo SJ-210 - Page 176

8. MODIFYING PARAMETERS
No. 99MBB122A
8-13
c Set the upper limit value.
When the value is set, press the [Enter/Menu] key.
NOTE
• When the upper limit is set to 0, GO/NG judgment by the
upper limit is disabled.
TIP
• Pressing the “AC” ([Blue] key) sets the value to 0.
To change the position of a decimal point, place the cursor
at the desired position and press the “Decimal” ([Red] key).
• For information about numeric value entry, refer to 2.5,
“Entering Numeric Values/Characters”.
d To set the lower limit value, press the “LowLimit” ([Blue] key).
e Set the lower limit value.
When the value is set, press the [Enter/Menu] key.
NOTE
• When the lower limit is set to 0, GO/NG judgment by the
lower limit is disabled.
TIP
• Pressing the “AC” ([Blue] key) sets the value to 0.
To change the position of decimal point, place the cursor at
the desired position and press the “Decimal” ([Red] key).
• For information about numeric value entry, refer to 2.5,
“Entering Numeric Values/Characters”.
 The set GO/NG judgment rule and the set upper and lower limit
values are displayed on the GO/NG Judgment Rule Setup screen.
TIP
• Press the [Esc/Guide] key to return to the previous screen.
Upper Limit Setup screen
GO/NG Judgment Rule
Setup screen
Lower Limit Setup screen
GO/NG Judgment Rule
Setup screen