Mitutoyo SJ-210 - Measurement Result Management; Loading;Saving;Deleting;Renaming Measurement Results; Outputting the Measurement Results

4. MEASUREMENT OPERATION
No. 99MBB122A
4-7
4.4 Measurement Result Management
The latest measurement results are retained in the memory of the SJ-210. Using a
memory card (optional), the SJ-210 can save the measurement results up to 10,000 cases
of measurements.
4.4.1 Loading/Saving/Deleting/Renaming measurement results
The operation flow of saving measurement results is explained here.
NOTE
• A memory card (optional) is required to perform loading/saving/deleting/renaming of
measurement results.
TIP
• A memory card (optional) is required to perform loading/saving/deleting/renaming of
measurement results.
• For information about loading/saving/deleting/renaming measurement results, refer to
Chapter 9, “MEASUREMENT RESULTS (LOAD/SAVE/DELETE/RENAME)”.
■ Procedure for saving measurement results
1 After measurement, switch the screens in the following order: Home → Main Menu
→ Measurement Result
2 Select “Save” with the cursor key, and press the [Enter/Menu] key.
3 Navigate to the save location folder with the cursor key, and press the [Enter/Menu]
key.
4 Select “Save New” with the cursor key, and press the [Enter/Menu] key.
5 Specify the file name, and press the [Enter/Menu] key.
 The measurement results are saved.
4.4.2 Outputting the measurement results
The SJ-210 has the function to output the measurement results (saved in the SJ-210
memory or the memory card) to a Mitutoyo Digimatic Data Processor (DP-1VR, etc.) or
personal computers.
The SJ-210 also has the function to print the measurement results when connected to a
printer (optional accessory).
TIP
• For information about outputting the measurement results, refer to Chapter 13, “SAVE
AND OUTPUT RESULTS USING [POWER/DATA] KEY”.