Mitutoyo SJ-210 - Switching the Measurement Units

10. OPERATING ENVIRONMENT SETUP
No. 99MBB122A
10-23
10.6 Switching the Measurement Units
When necessary, change the unit for the data such as the measurement results shown on
the display. The units can be set to “mm” or “inch”.
■ Operating procedure (Refer to “■ Accessing the Operating Environment Setup Menu screen” in Section
10.1.)
Home screen to Main Menu  
1 Select “Switch unit” with the [ ↑ ] [ ↓ ] keys, and press the
[Enter/Menu] key.
2 Select the unit of measurement to use with the [ χ ] [ ω ] keys,
and press the [Enter/Menu] key.
TIP
• Press the [Esc/Guide] key to return to the previous screen.
Operating Environment
Setup menu screen
Unit Selection screen