No. 99MBB122A
7-10
7.6 Modifying Items Related to Cut-off
Items related to cut-off that can be modified include the cut-off value (λc, λs),
measurement sampling length (ℓp, ℓ), and upper limit length (A).
NOTE
• You can modify the related cut-off item from the Home screen by pressing the shortcut
[ ← ] key. Press the [ ← ] key to cycle through the available values.
Here an example is given for modifying the value of λc. Other items related to cut-off can
be modified using similar procedures.
■ Operating procedure (For modifying λc) (Refer to “■ Accessing the Measurement Conditions screen” in
Section 7.1.)
Home screen to Main Menu
1 Select “λc” with the [ ↑ ] [ ↓ ] keys, and press the [Enter/Menu] key.
2 Select a cut-off value compatible with the target surface with the [ ↑ ]
[ ↓ ] keys, and press the [Enter/Menu] key.
The selected cut-off value (λc) is displayed on the Measurement
Conditions screen.
TIP
• Press the [Esc/Guide] key to return to the previous screen.
• When the Measurement Conditions screen has been
accessed using the shortcut [Red] key, pressing the
[Esc/Guide] key once returns you to the Home screen.
Measurement Conditions screen
Cutoff Value (λc) Setup screen
Measurement Conditions screen
To Next Page
Loading...
