Mitutoyo SJ-210 - Saving Measurement Conditions

No. 99MBB122A
7-30
7.13.2 Saving measurement conditions
A set of measurement conditions can be saved in the internal memory, or on the optional
memory card.
IMPORTANT
• A new memory card must be formatted with the SJ-210 before it can be used. The
memory card may not function properly when formatted in a device other than the
SJ-210. For information about formatting the memory card, refer to 10.10.1, “Formatting
the memory card”.
• When the built-in battery is completely depleted, or the built-in battery switch is set to
OFF, any measurement conditions saved to the internal memory is lost. It is
recommended to make periodic backups to the memory card. Refer to 10.10.5,
“Backing up the memory card and restoring backup data” for more information.
• When using the built-in battery, make sure it is sufficiently charged. If measurement
conditions are saved when the battery power is low, the SJ-210 may shut off while the
data is being saved.
■ Operating procedure (saving to the internal memory) (Refer to “■ Accessing the Measurement Conditions
screen” in Section 7.1.)
Home screen to Main Menu   
1 Set the measurement conditions.
2 On the Measurement Conditions screen, press the “Save” ([Red] key).
3 Select “Direct” with the [ ↑ ] [ ↓ ] keys, and press the [Enter/Menu] key.
Measurement Condition
Save Location screen
Measurement Conditions screen