Mitutoyo SJ-210 - Setting the GO;NG Judgment Function

8. MODIFYING PARAMETERS
No. 99MBB122A
8-9
8.3 Setting the GO/NG Judgment Function
The SJ-210 has a GO/NG judgment function. By using this function, a Go/No-go judgment
can be made for the measured surface roughness of a specimen.
One of 3 patterns, Mean, 16%, or Max, can be selected as the verification rule of the
GO/NG judgment function.
For the SJ-210, the GO/NG judgment function can be set to the selected parameters.
■ GO/NG judgment result display
When the GO/NG judgment function is used, the measurement data is compared with its
upper and lower tolerance limits. When the measurement falls outside the limits, the display
color of the measurement result changes. When the measurement is within tolerance limits,
the “OK” sign appears to the right of the parameter name. When the measurement exceeds
the upper limit, the “+NG” sign appears to the right of the parameter name, and the
displayed measurement result turns red. When the measurement falls below the lower limit,
the “-NG” sign appears to the right of the parameter name, and the displayed measurement
result turns blue.
GO/NG judgment result (within limit, above upper limit, below lower limit)
NOTE
• When the upper or lower limit is set to 0, the GO/NG judgment function based on the
limits is turned off. The upper limit and lower limit can be set individually. Therefore, it is
possible to individually disable the GO/NG judgment with the upper/lower limits.