Mitutoyo SJ-210 - Outputting SPC Data

No. 99MBB122A
13-6
13.1.3 Outputting SPC data
You can output calculation results from the SJ-210 to a DP-1VR when data output is set to
“SPC”.
With this setting made, calculation results are output when the [POWER/DATA] key on the
SJ-210, or the [DATA] key on the DP-1VR is pressed.
TIP
• For information about the connection of the SJ-210 and DP-1VR, refer to 13.1.1,
“Connecting the SJ-210 and DP-1VR”.
• For information about setting SPC output, refer to 10.3.1, “Setting the data output to
SPC”.
• You can load saved measurement data and output the calculation results. For
information about loading measurement data, refer to 9.4, “Loading Measurement
Results”.
■ Operation procedure
1 Perform the measurement.
TIP
• For information about measurement, refer to Chapter 4, “MEASUREMENT
OPERATION”.
2 Press the [POWER/DATA] key of the SJ-210 or the [DATA] button on the DP-1VR.
 Calculation results are output from the SJ-210 to the DP-1VR.
TIP
• For information on the statistical processing of measurement results, see the DP-1VR
User's Manual.