Mitutoyo SJ-210 - Recharging the Built-In Battery

No. 99MBB122A
3-14
3.4.1 Recharging the built-in battery
At the point of purchase, the built-in battery is not fully charged. Also, the built-in battery
switch is set to OFF. Before using the SJ-210, set the built-in battery switch to ON, and
charge the built-in battery.
NOTE
• The built-in battery cannot be recharged when the built-in battery on/off switch is set to
OFF. Make sure to set the battery switch to ON as explained below.
TIP
• When almost all the built-in battery power is exhausted, it takes about maximum 4 hours
to fully recharge it.
■ Recharging the built-in battery
1 Place your nail on the hollow provided on the rear cover, and push the rear cover in
the direction indicated by the arrow (1).
2 Pull the rear cover in the direction indicated by the arrow (2) and remove it.
Detaching the rear cover
3 Set the built-in battery on/off switch to ON.
Built-in battery on/off switch
4 Fit the rear cover to the hollow of the rear of the display unit in the direction indicated
by the arrow (1).
㧔1㧕
㧔2㧕
Rear cover
Built-in battery on/off switch
OFF ON