9. MEASUREMENT RESULTS (LOAD/SAVE/DELET/RENAME)
No. 99MBB122A
9-13
9.4 Loading Measurement Results
The saved measurement results on the memory card can be loaded.
When the saved measurement results are loaded, the existing SJ-210 internal memory is
overwritten with the saved measurement results, and the calculation results are displayed.
The following operations can be performed for the loaded results just as for the results
obtained through the measurement: recalculating the measurement results by modifying
the measurement conditions, printing data on the printer, resaving back to the memory
card.
IMPORTANT
• By loading the measurement results, the measurement conditions of the SJ-210 are
modified to that when the measurement results are saved.
• When using the built-in battery, make sure it is sufficiently charged. When the
measurement results are loaded while the level of the battery remainder power is low,
the power of the SJ-210 may be turned off during loading the data.
9.4.1 Loading the saved measurement results
■ Operating procedure (Refer to “■ Accessing the Measurement Data Menu screen” in Section 9.2.)
Home screen to Main Menu
1 Select “Read” with the [ ↑ ] [ ↓ ] keys, and press the [Enter/Menu] key.
2 Select the desired folder containing the measurement results to be
loaded with the [ ↑ ] [ ↓ ] keys, and press the [Enter/Menu] key.
TIP
• When the Save10 function is enabled, the results of the
latest 10 measurements are automatically saved in the
“Save10” folder. To load the results of the latest
measurement, select the “Read 10 Data”.
For information about the Save 10 function, refer to
10.10.4, “Setting the Save 10 Function”.
Measurement Result Menu screen
Load Folder Select screen
To Next Page
Loading...
