Mitutoyo SJ-210 - Support feet

No. 99MBB122A
14-2
■ Support feet
Used to measure a workpiece that is smaller than the drive/detector unit.
 Dimensions and application example
Use the support feet on the drive/detector unit to adjust it to the required height as
shown below.
Dimensions and application example of the support feet
 Attaching the support feet
1 Fit the two support feet in the grooves on the edges of the drive unit.
2 Adjust the height of the drive/detector unit so that it is parallel to the
measured surface.
3 After adjustment, fix the support feet by tightening the clamp screw
clockwise.
TIP
• For information about setting of drive/detector unit, refer to 4.3.1, “Setting the workpiece
and SJ-210”.
Attaching the support feet
Support feet
No. 12AAA216
Drive/detector unit
Workpiece
Clamp screw
Support feet
Drive
Guide groove
Detector