16. TROUBLESHOOTING
No. 99MBB122A
16-5
Symptom/Error
display
Possible causes Remedies
Data output is not set to “Saving data”.
Set the data output to “Saving data”.
Refer to 10.3.3, “Setting data output to save data”.
Data output is not set to “Hard copy”.
Set the data output to “Hard copy”.
Refer to 10.3.4, “Setting the data output to hard
copy”.
Memory card is not compatible with the SPI mode.
(SJ-210 gains access to the memory card in the
SPI mode.㧕
Memory card available in the market may not be
compatible with the SPI mode, so purchase the
memory card designated by Mitutoyo.
Card is inserted or removed while SJ-210 is
gaining access.
Insert or remove card while the power is turned off.
Inaccessible to the
memory
card.
File for the memory card has been edited by PC.
Memory card has not been formatted for the
SJ-210.
When using memory card for the first time, be sure to
format for the SJ-210.
Do not edit file using PC or other device.
PC-to-PC communication has been turned off. Turn on the pc-to-pc communication.
Refer to 10.13, “Setting PC Communication
Conditions”.
RS-232C Out of
communication.
Communication baud rate does not match the PC. Set the communication baud rate to the same
numeric value as that of the PC.
Refer to 10.13, “Setting PC Communication
Conditions”.
To Next Page
Loading...
