No. 99MBB122A
15-4
■ Canceling the detector retraction state of the SJ-210 standard type
1 Press the [POWER/DATA] key to turn on the power.
2 Press the [START/STOP] key.
The detector returns to the position it was in before retraction started. While the
detector is being moved, “Being returned” is displayed.
The Home screen is displayed after the extended out state has been released.
■ Detector retraction status of the SJ-210 retracting type
The SJ-210 retracting type detector is always extended to the front before starting
measurement. When the [START/STOP] key is pressed, the SJ-210 drives the detector
from the extended out position and starts measurement after passing the extension range.
Detector retraction status (SJ-210 retracting type)
NOTE
• In the SJ-210 retracting type and transverse tracing drive type, the detector escapes all
the way to the front with the detector tip down.
2 (Escaping range)
To Next Page
Loading...
