No. 99MBB122A
13-10
4 Press the [Enter/Menu] key.
The communication check is performed, and the printer's
communication settings are automatically configured.
When the communication check and the printer configuration are
complete, the message “Restart Printer” is displayed.
NOTE
• When an error message is displayed during the
communication check, manually set the printer's
communication conditions according to the below table.
For information on how to set the printer, see the printer's
user manual.
Setup item Setting value
COMMAND MODE MODE A
BAUD RATE 38400 bps
BIT LENGTH 8 bit
PARITY NON
BUSY CONTROL RTS/CTS
5 Press the [Enter/Menu] key.
6 Turn OFF, and then turn ON the printer power.
The printer can now be used.
Confirmation message
Confirmation message
To Next Page
Loading...
