Mitutoyo SJ-210 - Page 143

No. 99MBB122A
7-18
■ Operating procedure (Refer to “■ Accessing the Measurement Conditions screen” in Section 7.1.)
Home screen to Main Menu   
1 Select “N” with the [ ↑ ] [ ↓ ] keys, and press the [Enter/Menu] key.
2 Select “Opt Length” with the [ ↑ ] [ ↓ ] keys, and press the [Enter/Menu]
key.
3 Set an arbitrary evaluation length compatible with the target surface.
TIP
• Pressing the “AC” ([Blue] key) sets the value to 0.
To change the position of decimal point, place the cursor at
the desired position and press the “Decimal” ([Red] key).
• For information about numeric value entry, refer to 2.5,
“Entering Numeric Values/Characters”.
4 Press the [Enter/Menu] key.
 The set arbitrary evaluation length is displayed on the
Measurement Conditions screen.
TIP
• Press the [Esc/Guide] key to return to the previous screen.
• When the Measurement Conditions screen has been
accessed using the shortcut [Red] key, pressing the
[Esc/Guide] key once returns you to the Home screen.
Number of Sampling
Lengths Setup screen
Arbitrary Length Setup screen
Measurement Conditions screen
Measurement Conditions screen