8. MODIFYING PARAMETERS
No. 99MBB122A
8-19
4 Select the measurement type for the height of the count level, and press
the [Enter/Menu] key.
The background of the selected measurement type turns blue.
The set measurement type for the height of the count level is
switched to the predetermined type.
5 Setting the height of the count level.
a Select “Count Level” with the [ ↑ ] [ ↓ ] keys, and press the
[Enter/Menu] key.
b Input the height of the slice level.
The input range is as follows:
Peak reference: 0.0 to 99.9%/0.0 to 999.9m (9999.99 in)
Base reference: -50% to +50%/-999.9 to +999.9m (+/-9999.99 in)
TIP
• The value is set to 0 when the “AC” ([Blue] key) is pressed.
• For information about numeric value entry, refer to 2.5,
“Entering Numeric Values/Characters”.
HSC Setup screen
HSC Setup screen
HSC Setup screen
Count Level Setup screen
To Next Page
Loading...
