8. MODIFYING PARAMETERS
No. 99MBB122A
8-29
d Press the [Enter/Menu] key.
The set reference line is displayed on the δc (Htp for ANSI) setup
screen.
5 The number of slice levels to set matches the number of set slice points.
Settings that cannot be made have a gray background.
a Use the [ ↑ ] [ ↓ ] keys to select the parameters for a slice point.
b Select the slice level with the [←] [→] keys, and press the
[Enter/Menu] key.
c Input the slice level.
The input range is as follows:
0.0 to 999.9 m (9999.99 in)
TIP
• The value is set to 0 when the “AC” ([Blue] key) is pressed.
• For information about numeric value entry, refer to 2.5,
“Entering Numeric Values/Characters”.
δc Setup screen
δc Setup screen
δc Setup screen
Slice Level Setup screen
To Next Page
Loading...
