No. 99MBB122A
15-12
10 Reconnect the connector, which connects the top and bottom sections of the display
unit, and built-in battery pack connector to the board in the display unit.
NOTE
• When reconnecting the two connectors, note their location and orientation. Firmly
connect them. When the connectors are not firmly connected, the instrument may not
operate properly.
Connector connection
11 Couple the bottom section of the display unit with the top section.
IMPORTANT
• Exercise care not to have the cable pinched by the PCBs or by the upper and lower
sections of the display unit when fitting the lower section to the upper section. Cable
disconnection or display unit breakage may result.
To Next Page
Loading...
