No. 99MBB122A
3-22
● Power off with auto-sleep in use of the built-in battery
With the built-in battery in use and auto-sleep set to ON, when the SJ-210 is not operated
for more than a constant time after power-on, the power is automatically turned off with the
auto-sleep function.
Even when the power is turned off by the auto-sleep function, the measurement conditions
and results are retained and are displayed the next time the power is turned on.
NOTE
• When a request signal (REQUEST signal) is input from an external device during SPC
data output, the SJ-210 power is not turned off for a specified period of time after signal
input.
• When the power is being supplied by the AC adapter, the auto-sleep function is
disabled.
To turn the power off, keep pressing the [Esc/Guide] key.
TIP
• For more information about the auto-sleep function, refer to 3.4.3, “Setting the
auto-sleep function when using the built-in battery”.
To Next Page
Loading...
