5. MEASUREMENT RESULT DISPLAY
No. 99MBB122A
5-11
3 To check the measurement results at each sampling length and the
GO/NG judgment results for each parameter, select the desired
parameter with the [ ↑ ] [ ↓ ] key, and press the [Enter/Menu] key.
When a parameter is selected, the upper and lower roughness limits
that have been specified in the GO/NG judgment settings are
displayed at the bottom of the screen.
4 Check the measurement results at each sampling length and the
GO/NG judgment results.
When the measurement results are over the upper limit, at each
sampling length, the sampling length part is displayed in red. When the
measurement results are below the lower limit, the sampling length
part is displayed in blue.
TIP
• Press the [Esc/Guide] key to return to the previous screen.
Measurement Result at Each
Sampling Length screen
Sampling Lengths Result screen
To Next Page
Loading...
