Hardware
121
Installation and Connection
Describes installation and connection of the server.
Installation
This server should be mounted in a standard EIA 19-inch rack cabinet.
Installation of the rack cabinet
Refer to the documentation attached to the rack or contact your service representative for the
installation of the rack cabinet.
Make sure that the rack is the one specified for the server.
Observe the following instructions to use the server safely. Failure to follow these
instructions may result in death or serious personal injury. Refer to descriptions
after page iii for details.
●Do not use the server in any unapproved place.
Observe the following instructions to use the server safely. There are risks of
fire, personal injury, or property damage. Refer to descriptions after page
iii for details.
● Do not carry or install the rack only by a single person.
● Do not install the rack in a place where the load is concentrated on a specific
point.
● Do not install any components only by a single person.
● Do not pull out a device from the rack if the rack is unstable.
● Do not pull out more than one device at a time from the rack.
● Do not provide wiring exceeding the rating power.
WARNING
CAUTION
To Next Page
Loading...
