NEC Express 5800 - Sensor Information; Enumeration of All Sensors

567
3 Sensor Information
You can retrieve sensor information of all sensors or of the specified sensor.
3.1 Enumeration of All Sensors
Enter the following command, if you enumerate numeric sensors (e.g.: temperature, voltage)
with WinRM.
winrm enumerate
http://schemas.dmtf.org/wbem/wscim/1/cim-schema/2/CIM_NumericSensor
-username:USERNAME -password:PASSWORD -r:PROTOCOL://IP_ADDRESS/wsman
-auth:basic -encoding:utf-8 -skipCAcheck -skipCNcheck -skipRevocationcheck
Enter the following command, if you enumerate non-numeric sensors (e.g.: Processor, Memory,
PSU, FAN) with WinRM.
winrm enumerate http://schemas.dmtf.org/wbem/wscim/1/cim-schema/2/CIM_Sensor
-username:USERNAME -password:PASSWORD -r:PROTOCOL://IP_ADDRESS/wsman
-auth:basic -encoding:utf-8 -skipCAcheck -skipCNcheck -skipRevocationcheck
IMPORTANT:
Followings are about parameters used in operation image.
 To run power management service for the Server1, please
specify the IP Address of Server Web Console(Server1) to the
“IP_ADDRESS”, and specify user account and password for
login to server web console to the “USERNAME/PASSWORD”.
As for user account and password, see “2.6 User Management”
in the web console section.
 For Server2, please follow to similar manner.
 Please specify the “http” or “https” to “PROTOCOL”.