NEC Express 5800 - Service Processor

506
2.15 Service Processor
Service Processor is displayed by “Service Processor” from the menu on the left side of the
screen.
Management Firmware reboot(reset) and collecting all the hardware logs inside the server can
be performed in Service Processor.
(1) Clicking “SP Reset” enables to reset all the MGMs configuring the server.
(1)
(2)
(3)
(4)
IMPORTANT:
 NEC unrecommends the "SP Reset" operation to you while the
DC power is on because the application of the OS may not work
well.
 In A1080a-D model, if another server is starting up, don’t
execute “SP Reset” operation until the status of another server
will be “OS Running or EFI Manager Booted”.
 Don't execute “SP Reset” operation until the status of this
server will reach to “Stopped” after power-off.
 In A1080a-D model, if another server is stopping, don’t execute
“SP reset” operation until the status of another server will reach
to “Stopped”.
IMPORTANT:
 Don’t run firmware update operation during VMware ESX/ESXi
running。