Hardware
350
Configuring Virtual Disk
This section describes the procedures for configuration of VD (virtual disk) using WebBIOS.
Configuration Wizard
When you select [Configuration Wizard] on WebBIOS Home Menu and press Enter, the screen as
shown below appears. Select the relevant operation, and select [Next] at lower right of the screen,
then press Enter.
Clear Configuration: Allows to clear existing configuration.
New Configuration: Clears the existing configuration and creates a new VD. If
you have any existing data in the earlier defined virtual disk,
the data will be lost.
Add Configuration: Retains the old configuration and then adds new VD.
IMPORTANT:
For A1080a-S/A1080a-D/A1080a-E, the allowable number of virtual
disks is up to 16 per disk group, or up to 24 per partition(server).
To Next Page
Loading...
