Operation and Maintenance
609
EXPRESSBUILDER
Unable to start EXPRESSBUILDER
□ Did you set EXPRESSBUILDER during POST and restart the server?
→ If you do not set EXPRESSBUILDER during POST and restart the server, an error
message will appear or the OS will boot.
□ Is BIOS configuration correct?
→ The BIOS setup utility allows you to configure the boot order of the boot devices.
Configure the boot order so that the optical disk drive will be the first to start up.
<Menu to check: [Boot]>
□ Is a message such as the following displayed?
Message Cause
This EXPRESSBUILDER version is not designed for
this computer.
Insert the correct version and click [OK].
This EXPRESSBUILDER version is not designed for this
server. Execute EXPRESSBUILDER provided with the
server.
EXPRESSBUILDER could not get the hardware
parameters ofthis motherboard.
This version is not designed for this computer or the
motherboard may be broken.
This message is shown when EXPRESSBUILDER could
not find system-specific information on the motherboard.
Contact the maintenance service company.
The file that EXPRESSBUILDER tried to operate was
not found.
The file that EXPRESSBUILDER tried to operate was
not able to open.
EXPRESSBUILDER can not get the parameters of the
definition file.
EXPRESSBUILDER cannot be read.
Media may be defective or the optical disk drive may be
faulty.
Contact the maintenance service company.
To Next Page
Loading...
