Hardware
172
When you fail to eject:
When you fail to eject the tray with the tray eject button and cannot take out the CD/DVD-ROM
from the server, follow the procedure below.
1. Press the POWER switch to power off the server.
2. Insert a metal pin of approximately 1.2mm
In dismeter and 100mm in length(a strainghtend
large paper clip will make a substitute) into the
emergency hole on the lower front of the DVD
drives and gently push it in the tray is ejected.
3. Hold the tray and pull it out.
4. Take out the CD/DVD-ROM.
5. Push the tray back into the drive.
IMPORTANT:
● Do not use a toothpick or plastic
stick that is easy to break.
● If the above procedure does not
let you take out the CD/DVD-ROM,
contact your service
representative.
To Next Page
Loading...
