424
1.8.1 Enable/Disable Component
Enable/Disable Component is displayed by selecting “Fault Information” and clicking
“Enable/Disable” of the menu on the left side of the screen.
There are no system level components that an operator can enable or disable on the system web
console.
(1) Display/set Enable/Disable status.
6
Contents to be displayed are as follows.
Setting : Enable/Disable status
Name : Disable sensor name
(2) Clicking “Submit” enables to set the information of (1).
7
(3) Clicking “Cancel” enables to move to Fault Information screen.
6
There are no sensors which should be displayed on system web console.
7
Not supported in system web console.
(1)
(2)
(3)
To Next Page
Loading...
