423
1.8 Fault Information
Fault Information is displayed by selecting “Fault Information” from the menu on the left side of
the screen.
There are no system level sensors in the system web console. If this page will be loaded, “There
are no sensors present in the system.” message will be displayed.
(1) If “Clear All” button is clicked, the following process will be done,
- Restore the failure status of all resources in system to normal status.
(2) Clicking “Enable/Disable” enables to move to Enable/Disable Components screen.
(3) Display Fault sensor information.
5
Name : Fault sensor name
Status : Status
5
Not supported in system web console.
(1)
(2)
(3)
To Next Page
Loading...
