EasyManua.ls Logo

NEC Express 5800 - Setting1 Target

NEC Express 5800
719 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
551
oemnec_cputhrottle=00
oemnec_cputhrottle_current=00
ufip=/resource1
Guid=3F2504E0-4F89-11D3-9A0C-AABBCCD
DEEFF
Display DeviceGUID of the
resource
ufip=/resource1/nic1
ipaddress=192.168.1.127
subnetmask=255.255.255.0
usedhcp=0
committed=1
macaddress=00:00:4C:02:C7:9B
defaultgatewayaddress=0.0.0.0
Display and Set the
resource network
ufip=/maintenance1/
nic1
ipaddress= 172.16.255.254
subnetmask=255.255.0.0
macaddress=00:00:4C:88:88:88
Display and Set the
maintenance network
setting1 target
Below is the properties for the target.
Timeout :
Specify the time of the session timeout.
If there is no key operation with pressing Enter key by operator for the specified time, it
logouts automatically and close SMASH-CLP. If “0” is specified, the time is unlimited.
Example (set the time for 1200 seconds, 20 minutes)
-> set timeout=1200
IMPORTANT:
•Don’t use set command which changes the MAC address
because it might cause malfunction of the management
firmware.
IMPORTANT:
•The GUID is big-endian.
IMPORTANT:
•It is possible to set some targets for the default gateway
address. However, the final setting is valid. Only one default
gateway can be existed for the management firmware.
IMPORTANT:
•The setting is valid even after reset of the management
firmware. This setting is saved and restored as SG information.
•The default setting is 500 seconds (about 8 minutes).

Table of Contents

Other manuals for NEC Express 5800

Related product manuals