489
2.10.1 Enable/Disable Component
Enable/Disable Component is displayed by selecting “Fault Information” and clicking
“Enable/Disable” of the menu on the left side of the screen.
Hardware unit status (Enable/Disable) can be checked and Enable/Disable setting can be
performed manually in Enable/Disable Component.
(1) Display/set Enable/Disable status.
Displayed contents are as follows.
Setting : Enable/Disable status
Name : Disable sensor name
(2) Clicking “Submit” enables to set the information of (1).
(3) Clicking “Cancel” enables to move to Fault Information screen.
(1)
(2)
(3)
IMPORTANT:
If the non-redundant hardware unit is set to “Disabled”, the
server cannot be booted.
If the hardware unit which has previously set to “Disabled” is
set to “Enable” at the time of failure, the same hardware unit
failure may reoccur it may temporarily recover.
To Next Page
Loading...
