Operation and Maintenance
653
Selecting/Unselecting Test Device
Use <select> command to select the test device, and <desel> command to unselect the test
device.
The following is an example of screen using the command.
• The execution result of <select> is confirmed by <list> command.
• The followings are three ways of specifying the test device.
Specifying “Test device
number”
:
Specifies the test device number in “Num” row.
This specifies devices individually. With “+” or
“-” added on the top of the device name, all the
devices under the tree is selected.
Specifying “Test device type”
:
Specifies the test device type of “Type” row.
This specifies the same type of devices.
Specifying “all”
: Specifies all the test devices.
TeDoLi> select 17
TeDoLi> list
+----+-+---------------------------------+------------+----+-------------+
| Num|*| Device List | Type |Prev| Status |
+----+-+---------------------------------+------------+----+-------------+
| 1| | MEMORY |MEMORY | | |
| 2|!|-MGM2 |MODULE | | |
| 3|!| -MGM2/MGB/GbE |NIC | | |
| 4| | Port1(eth1) |ETH-PORT | | |
| 5| | Port2(eth2) |ETH-PORT | | |
| 6|!|-PMM5 |MODULE | | |
| 7| | PMM5/PMB/PROC |CPU | | |
| 8|!|-PMM6 |MODULE | | |
| 9| | PMM6/PMB/PROC |CPU | | |
| 10|!|-BM |MODULE | | |
| 11|!| -BM/MB/PCI1 |SCSI(NoDev) | | |
| 12|!| Port1 |SCSI-PORT | | |
| 13|!| -BM/MB/PCI8 |NIC | | |
| 14| | Port1(eth0) |ETH-PORT | | |
| 15|!| -BM/MB/PCI9 |FC | | |
| 16|!| -Port1 |FC-PORT | | |
| 17|*| SCSI-ID0 LUN0(iStorage 1000) |HDD | | |
| 18|!| Port2 |FC-PORT | | |
| 19| | DV-28S-V |DVD | | |
+----+-+---------------------------------+------------+----+-------------+
To Next Page
Loading...
