NEC Express 5800 - I;O Related; Stall Monitoring Related

54
I/O Related
Operation Mode Default Option Setting Procedure
Wake On LAN
• Set to enable/disable Wake On
LAN
Enable
Enable,
Disable
Server Web Console
→ Settings
→ Mode Settings
PCI Slot 1 - 14 OpROM
• Set to enable/disable BIOS
installed on the device (board)
connected to the PCI bus
Slot1,14
=Enable
Slot2 - 13
=Disable
Enable,
Disable
BIOS SETUP
→ Advanced Menu
Launch PXE/iSCSI ROM
• Set to enable/disable BIOS
expanding of legacy network
device
Enable
Enable,
Disable
BIOS SETUP
→ Advanced Menu
Launch Storage ROM
• Set to enable/disable BIOS
expanding of large capacity
legacy storage device
Enable
Enable,
Disable
BIOS SETUP
→ Advanced Menu
LAN Controller
• Set to enable/disable LAN
controller
Enable
Enable,
Disable
BIOS SETUP
→ Chipset Menu
LAN1 Option ROM Scan
• Set to enable/disable BIOS
installed on the LAN 1 controller
Enable
Enable,
Disable
BIOS SETUP
→ Chipset Menu
LAN2 Option ROM Scan
• Set to enable/disable BIOS
installed on the LAN 2 controller
Enable
Enable,
Disable
BIOS SETUP
→ Chipset Menu
Stall Monitoring Related
Operation Mode Default Option Setting Procedure
BIOS POST Stall Policy
• Set BIOS/POST stall monitoring
10 minutes 1 – 60 minute(s)
Server Web Console
→ Settings
→ Mode Settings
OpROM Stall Policy
• Set OpROM stall monitoring Disable
Enable,
Disable
Server Web Console
→ Settings
→ Mode Settings
OS Boot Stall Policy
• Set OS boot stall monitoring Disable
Enable,
Disable,
1 – 100 minute
Server Web Console
→ Settings
→ Mode Settings
Failure Flow Stall Policy
• Set failure process stall monitoring
30 minutes
Enable,
Disable,
1 – 60 minute
Server Web Console
→ Settings
→ Mode Settings
Shutdown Stall Policy
• Set shutdown stall monitoring 10 minutes
Enable,
Disable
1 – 60 minute
Server Web Console
→ Settings
→ Mode Settings