51
Operation Mode
The server supports the following operation modes, and these modes can be set and changed.
Each setting can be changed on EXPRESSSCOPE® Monitor, BIOS SETUP, and Web Console.
Refer to the corresponding section of “Hardware” for details on the setting procedure, etc.
System (Platform) Level Setting
DVD/USB Setting
Operation Mode Default Option Setting Procedure
Switch DVD and Front USB
• Set which of the server is used for
the DVD drive in the front of the
server and the USB port on
A1080a-D model.
Server 1
Server 1,
Server 2
EXPRESSSCOPE®
Monitor
→ System Menu
System Web Console
→ Settings
→ Hardware Settings
Power Related
Operation Mode Default Option Setting Procedure
Power Redundancy
• Power redundancy setting N+1 2N, N+1, N
System Web Console
→ Settings
→ Mode Settings
Policy when Power Redundancy
Lost
• Set processes when power
redundancy is lost (priority on
performance/keeping
redundancy/recovering
redundancy)
Performance
Performance,
Keep,
Recover
System Web Console
→ Settings
→ Mode Settings
Processor Power Control
• Set processor power consumption
control
Passive
Passive,
Active
System Web Console
→ Settings
→ Mode Settings
Other
Operation Mode Default Option Setting Procedure
Maintenance Mode
• Set it is under maintenance
(Report is stopped while this mode
is set)
Disable
Enable,
Disable
EXPRESSSCOPE
®
Monitor
→ System Menu
System Web Console
→ Settings
→ Mode Settings
To Next Page
Loading...
